Filling The Moistener Tank - Pitney Bowes SendPro С User Manual

5. Remove the metal grate and wick from the moistener base.
6. Clean the brush and wick with water and rinse thoroughly.
7. Place the wick back in the metal grate and replace the grate in the moistener base.
8. Slide the moistener brush back into the holder.
9. Replace the moistener brush assembly on top of the moistener base and secure with the plastic
thumbscrew.

Filling the moistener tank

Fill the moistener tank periodically with E-Z Seal® to seal your envelopes.
1. Check the level of E-Z Seal® in your moistener tank.
2. Add enough E-Z Seal® to bring the sealant level up to the bottom of the fill hole. Do not overfill
your tank.
3. If the tank is empty, allow 30 minutes for the moistener brush and wick to get completely saturated.
Pitney Bowes User Guide November 2020
10 • Maintenance
108