Parking Brake Adjustment - Briggs & Stratton Ferris IS5100Z Series Dealer Setup & Adjustment Instructions Manual

Parking Brake
Adjustment
1. Disengage the PTO, stop the engine, block the front
wheels, remove the ignition key, and engage the
parking brake.
2. Locate the upper brake spring (A, Figure 39) through
the opening under the fuel tanks.
3. With the parking brake engaged, measure the
compressed spring length. The spring should be
2" to 2-1/8" (5,0-5,4cm) when compressed.
4. If adjustment is required, disengage the parking
brake and turn the adjustment nut (B).
5. Engage the parking brake and re-measure the
spring.
CAUTION
Do not adjust the spring to be shorter than
2" (5,0cm) when compressed. This may damage
the brake caliper.
IS5100Z Series - 33 HP Diesel
Figure 39. Parking Brake Adjustment
A. Upper Brake Spring
B. Adjustment Nut
19
61" iCD Mower Deck
FRONT
2" - 2-1/8"
(5,0 - 5,4cm)
A
B