Table of Contents
Advertisement
IS5100Z Series - 33 HP Diesel
61" iCD Mower Deck
Battery Installation
Install Battery
WARNING
BATTERY SAFETY RULES
• Battery acid causes severe burns. Avoid contact
with skin.
• Wear eye protection while handling the battery.
• To avoid an explosion, keep flames and sparks
away from battery, especially while charging.
• When installing battery cables,
CONNECT THE POSITIVE (+) CABLE FIRST and
negative (-) cable last. If not done in this order,
the positive terminal can be shorted to the frame
1. Raise the seat plate to expose the battery
compartment.
2. Connect the red positive battery cable (B, Figure 4)
to the positive battery post.
3. Connect the black negative battery cable (A) to the
negative battery post.
Tractor
Assembly
Motion Control Handle Assembly
1. Remove the handles and mounting hardware from
the handle bar box.
2. Assemble the control handles to the square bases
using the 5/16-18 x 1" bolts, lock washers and flat
washers. There are two sets of holes available for
the handle height. Assemble the handles in the
same set of holes for both sides.
NOTE: There are a LEFT-HAND and a RIGHT-HAND
control handle. When assembled to the base, the
handle should tilt forward as shown in Figure 5.
Seat Assembly
1. Unpack the seat.
2. Install the seat onto the seat mount plate and secure
with the 5/16-18 nylock flange nuts.
A
Figure 4. Battery Installation
A. Negative Cable
B. Positive Cable
C. Hold-Down Strap
A
Figure 5. Control Handle Installation
(right-hand side shown)
A. 5/16-18 x 1" Bolts, Lock Washers and Flat Washers
4
C
B
Advertisement
Table of Contents
