Parking Brake Adjustment - Briggs & Stratton 5900731 Instruction Manual

Zero-Turn Riding Mower - 48" Mower Deck
Parking Brake
Adjustment
1. Disengage the PTO, stop the engine, engage the
parking brake, and remove the key from the ignition.
2. Raise the seat plate to gain access to the parking
brake components.
3. Measure the distance from the top of the brake
spring rod (C, Figure 21) to the top of the lock nut
(D) on both sides of the unit. The measurement
should be .50" (1,27 cm). If not, adjust the locknut to
achieve the measurement of .50" (1,27 cm)
4. Measure the distance between the bottom of the
brake shaft weldment (G) and the top of the set
collar (F). The measurement should be .375"
(0,95 cm). If not, position the set collar until the
measurement equals .375" (0,95 cm).
Briggs & Stratton Power Products Group, LLC.
Copyright © 2014 Briggs & Stratton Corporation
Milwaukee, WI, USA. All rights reserved.
SIMPLICITY is a trademark of Briggs & Stratton
Corporation Milwaukee, WI, USA.
Contact Information:
Simplicity Manufacturing, Inc.
P.O. Box 702
Milwaukee, WI 53201-0702
1-800-837-6836
Simplicitymfg.com
SNAPPER is a trademark of Briggs & Stratton
Corporation Milwaukee, WI, USA.
Contact Information:
Snapper Products
535 Macon St.
McDonough, GA 30253
1-800-837-6836
Snapper.com
A
G
Figure 21 - Parking Brake Adjustment
A. Brake Spring
B. First Measurement - .50" (1,27 cm)
C. Brake Spring Rod
D. Lock Nut
E. Second Measurement - .375" (0,95 cm)
F. Set Collar
G. Brake Shaft Weldment
MASSEY FERGUSON is a trademark of AGCO
Corporation. Used under license.
Contact Information:
Massey Ferguson Lawn and Garden
Simplicity Manufacturing, Inc.
P.O. Box 702
Milwaukee, WI 53201-0702
1-800-837-6836
MasseyLawn.com
12
C
B
D
E
F