Uncrating - Briggs & Stratton Ferris IS5100Z Series Dealer Setup & Adjustment Instructions Manual

Uncrating

1. Using a reciprocating utility saw or equivalent, cut
crate away from bottom skid. Remove crate. Remove
shrink-wrap plastic.
2. Cut banding from front and rear tractor axles. Cut
banding from mower rollers. Remove mower deck
from the bottom skid.
IMPORTANT NOTE
When cutting crate from bottom skid,
use caution around tractor tires and
mower rollers.
3. Open the hydraulic release valves. To open the
release valves, turn the right-hand release valve,
which is located on top of the right-hand pump,
counter-clockwise 2 full turns MAX. Then turn the left-
hand release valve, which is located on the bottom
of the left-hand pump, counter-clockwise 2 full turns
MAX. See Figure 1 for valve location.
4. Inflate rear tires to 18 psi (1,24 bar).
5. Remove the rear bumper from the shipping position
(B, Figure 2). With same hardware, install the
bumper in operating position (A). Tighten the
hardware securely.
6. Push down on parking brake lever (A, Figure 3) to
release parking brake.
7. Be sure there are no nails or sharp objects on bottom
skid to puncture the tractor's tires. Roll the tractor
forward off the bottom skid.
8. After moving the tractor, re-engage the pumps (drive
position) by turning the release valves clockwise and
tighten to 80-120 in/lbs (9-13.5 N.m.).
IS5100Z Series - 33 HP Diesel
A
Figure 1. Hydraulic Release Valve Location
A. Hydraulic Release Valve (Right-hand side shown)
Figure 2. Bumper Install
A. Operating Position
B. Shipping Position
A
Figure 3. Disengaging the Parking Brake
(lever shown in disengaged position)
A. Parking Brake Lever
3
61" iCD Mower Deck
A
B