Table of Contents
Advertisement
Adjustment
Procedures
Seat Adjustment
See Figure 34. The seat can be adjusted fore and aft.
Move the lever forward, position the seat as desired,
and release the lever to lock the seat into position.
Ground Speed Lever
Adjustment
The control levers can be adjusted in three ways. The
alignment of the control levers, the placement of the
levers (how close the ends are to one another) and the
height of the levers can be adjusted.
HANDLE ALIGNMENT
Loosen the mount hardware (A, Figure 35) and pivot
the lever(s) (C, Figure 40) fore or aft to align with each
other.
HANDLE PLACEMENT
Loosen the jam nuts and adjust the placement bolt (B,
Figure 35) in or out to properly adjust the lever end
spacing.
HANDLE HEIGHT
Remove the mounting hardware (A) and reposition the
handle either up or down from its original position. You
will need to readjust the handle alignment as described
above.
Speed Balancing
Adjustment
If the rider veers to the right or left when the ground
speed control levers are in the maximum forward
position, the top speed of each of these levers can be
balanced by turning the adjustment bolt(s) (A, Figure
36). Only adjust the speed of the wheel that is traveling
faster.
To Reduce the Speed of the Faster Wheel
1. Loosen the jam nut (B).
2. turn the top speed adjustment bolt CLOCKWISE to
reduce the speed.
3. Retighten the jam nut when adjustment is complete.
IS5100Z Series - 33 HP Diesel
Seat
Adjustment
Lever
Figure 34. Seat Adjustment
A
B
Figure 35. Control Lever Adjustment
A. Alignment Hardware
B. Placement Hardware
C. Ground Speed Control Lever
A
Figure 36. Top Speed Adjustment
A. Top Speed Adjustment Bolt
B. Jam Nut
WARNING
DO NOT adjust the tractor for a faster overall
speed forward or reverse than it was designed for.
17
61" iCD Mower Deck
C
B
Advertisement
Table of Contents
