Checks Before Starting; Seat Adjustment - Briggs & Stratton Snapper Pro S800X Series Operator's Manual

Checks Before Starting

• Check that crankcase is filled to full mark on the engine
oil dipstick (A, Figure 1). See the engine Operator's
Manual for instructions and oil recommendations.
• Fill the fuel tank (B) with fresh fuel. Refer to engine
manual for fuel recommendations.
• Make sure all nuts, bolts, screws and pins are in place
and tight.
• Check the tire pressures. See Check Tire Pressures.
• Check the hydraulic oil tank (C) and make sure that the
oil level is up to the FULL COLD mark.
• Adjust the height of the mower deck to the desired
position. See Mowing Height Adjustment.
• Adjust the seat position, and make certain you can reach
all controls from the operator's position.
• Make sure that the fuel valve (D) is in the ON position.

Seat Adjustment

The seat can be adjusted forward and backward.
S/N: 2014648787 & Below: Move the lever (A, Figure 2)
forwards, position the seat as desired, and release the lever
to lock the seat into position.
S/N: 2014648788 & Above: Move the lever (B) to the left,
position the seat as desired, and release the lever to lock the
seat into position.
D
Figure 1. Pre-start Checks (Unit Shown With Hood Raised)
A. Engine Oil Dipstick
B. Fuel Tank Cap
C. Hydraulic Oil Fill
D. Fuel Selector Valve
A
B
Figure 2. Seat Adjustment
A. Seat Adjustment Lever - S/N: 2014648787 & Below
B. Seat Adjustment Lever - S/N: 2014648788 & Above
Operation
C
B
A
17 17