Fault (!) Led (One Led Per Port) - IBM Flex System EN4023 User Manual

1
FIGURE 12
Table 6
TABLE 6
Status LED
Ethernet Link LED (green)
Ethernet Tx/Rx LED (green)
System status LEDs
Three system LEDs are located at the bottom of the front panel that identify system status, as
shown in
During power-on self-test (POST), the switch performs internal tests and LED tests. During POST,
the LEDs are lit intermittently. After POST is successfully completed, the LEDs will behave as
described in
1
2
FIGURE 13
Introduction
Locating the information panel, LEDs, and external ports
Tx/Rx LED
RJ-45 Ethernet port LEDs
identifies the Ethernet port status LEDs.
RJ-45 Ethernet port status LEDs
Figure 13.
Table 7 and Table
Power LED
Location LED
System status LEDs
2 Link LED
Description
No light. There is no link.
Steady green. There is a link.
Flashing green. There is link activity.
No light. Port speed is 10 Mbps.
Steady green. Port speed is 100/1000 Mbps.
8.
3 Fault LED
2
23