Table of Contents
Advertisement
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A` Laser de Classe 1
Inserting an SFP+ or QSFP transceiver
To insert an SFP+ or QSFP transceiver, complete the following steps:
1. Read the safety information that begins on
2. Read the information in
3. Remove the transceiver from its static-protective package.
4. Remove the protective insert, if one is installed, from the port where you are installing the
5. Gently insert the transceiver in a port on the switch until it clicks into place.
Introduction
page 9.
"Handling an SFP+ or QSFP transceiver"
transceiver and store it in a safe place.
a. For SFP+ transceivers, use ports 43 through 56. See
b. For QSFP transceivers, use ports 57 and 58. See
ATTENTION
To avoid damage to the cable or transceiver, make sure you install the transceiver before you
connect the fiber-optic cable.
Installing and removing an SFP+ or QSFP transceiver
page vii
and
Figure
"System reliability guidelines"
on page 14.
Figure
5.
6.
2
on
15
Advertisement
Table of Contents
