Table of Contents
Advertisement
NOTE
You can also use the CMM to ensure that the switch is operating correctly. For more information, see
the documentation for the chassis.
For more information, refer to the following sections:
•
•
•
SFP+ and QSFP port LEDs
Each SFP+ and QSFP port has two LEDs. The Tx/Rx LED is green when lit; the Fault (!) LED is amber
when lit. When lit, LEDs are shown as either steady or flickering.
Figure 10
1
FIGURE 10
Figure 11
LEDs are shown as solid green when operating properly, regardless of whether or not breakout
mode is configured.
Introduction
"SFP+ and QSFP port LEDs"
"Ethernet port status LEDs"
"System status LEDs"
on page 23
shows the port status LEDs for the SFP+ ports.
Tx/Rx LED
SFP+ port LEDs
shows the port status LEDs for the QSFP ports. If you are using ports 57 and 58, Tx/Rx
Locating the information panel, LEDs, and external ports
on page 21
on page 22
2
Fault (!) LED
2
21
Advertisement
Table of Contents
