Removing Or Replacing An Sfp+ Or Qsfp Transceiver - IBM Flex System EN4023 User Manual

2
Installing and removing an SFP+ or QSFP transceiver
FIGURE 5
FIGURE 6
6. Connect the fiber-optic cable to the SFP+ or QSFP transceiver. For information about protecting
7.

Removing or replacing an SFP+ or QSFP transceiver

To remove an SFP+ or QSFP transceiver, complete the following steps:
1. Read the safety information that begins on
2. Read the information in
3. Remove the fiber-optic cable from the SFP+ or QSFP transceiver that you want to replace.
16
SFP+ transceiver installation
QSFP transceiver installation
the cable, see "Handling an SFP+ or QSFP transceiver"
Check the LEDs on the switch. When the switch is operating correctly, the green Link LED is lit.
For information about the status of the switch LEDs, see
page 9.
"Handling an SFP+ or QSFP transceiver"
ATTENTION
To avoid damage to the cable or the SFP+ or QSFP transceiver, make sure you disconnect the
fiber-optic cable before you remove the SFP+ or QSFP transceiver.
on page 14.
"Information LEDs"
page vii and "System reliability guidelines"
on page 14.
IBM Flex System EN4023 10Gb Scalable Switch User's Guide
on page 20.
on