Siemens SINUMERIK 840D sl Function Manual page 134

B3: Several operator panels connected to several NCUs, distributed systems - only 840D sl
2.3 Several operator panel fronts and NCUs, standard functionality
Vocabulary words:
param: Introduces parameter for operator component
name: User-defined name for the operator component to be described
type: Operator component type
mmc_address: Bus address of operator component
V. Description of NCU component(s)
A separate entry must be generated for each NCU component connected to the bus.
Table 2- 5
Descriptive entry
Header
Next lines (optional)
(optional)
*)
*)
NCU_ID:
bel_name:
name entered here (e.g. NCU1) is also output in the alarm line.
ncu_561|ncu_571|ncu_572|ncu_573:
NCU)
j:
Address of NCU component on the bus:
p:
Address of PLC component on the bus:
If bus = opi, the same value must be entered for
*) If bus = mpi, the following applies: Since the associated NCU always occupies the next-
higher address than the PLC, the PLC address must not be 31. Address 31 can, for
example, be assigned to a PCU.
Vocabulary words:
param: Introduces parameter for NCU component
name: User-defined name for the NCU to be described
type: NCU type
nck_address: Bus address of NCU
plc_address: Bus address of PLC
Note
If the bus node addresses on the MPI bus are configured in conformance with SIMATIC, the
configuring engineer can read out the assigned addresses using a SIMATIC programming
device and use them to create the NETNAMES.INI file.
134
Description of NCU component
Formal
[param
name=
type=
ncu_572 | ncu_573
nck_address =
plc_address =
Entry for NCU component.
User-defined name with a maximum of 32 characters; with HMI Advanced, the
NCU_ID
]
any_name
ncu_561 | ncu_571 |
j
p
,
NCU type (ncu_561 not with configuration 1 PCU, 3
j
= 1, 2, ... 31 *)
p
= 1, 2, ... 31 *)
j p
and .
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Example
[param NCU_1]
name= NCU1
type= ncu_572
nck_address = 13
plc_address = 13
Extended Functions