Installing And Removing The Shaft-Mounted Gearbox; General Information On Installing The Shaft-Mounted Gearbox - Siemens SIMOGEAR BA 2030 Operating Instructions Manual

4.9

Installing and removing the shaft-mounted gearbox

4.9.1

General information on installing the shaft-mounted gearbox

NOTICE
Damage to shaft sealing rings caused by solvent
Avoid any contact of solvent or benzine with the shaft sealing rings.
NOTICE
Subjecting stress to the hollow shaft causes bearing failure
Skewing or stressing the hollow shaft increases the loading. This can cause bearing failure.
The hollow shaft must be flush with the machine shaft to avoid misalignment.
Do not subject the hollow shaft to axial and radial stress.
NOTICE
For shrink disks:
Lubricants in the area between the hollow shaft and machine shaft impair torque
transmission
Keep the bore in the hollow shaft and the machine shaft completely grease-free.
Do not use impure solvents and soiled cleaning cloths.
Note
Coat the contact surfaces with the mounting paste supplied with the product or any suitable
lubricant to prevent frictional corrosion.
Note
Observe the permissible concentricity tolerance of the cylindrical shaft extension of the
machine shaft to the housing axle according to DIN 42955.
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
4.9 Installing and removing the shaft-mounted gearbox
Installation
35