Hollow Shaft With Splines - Siemens SIMOGEAR BA 2030 Operating Instructions Manual
Gearbox
Hide thumbs
Also See for SIMOGEAR BA 2030:
Table of Contents
Advertisement
4.9.4
Hollow shaft with splines
*
①
②
③
④
⑤
⑥
⑦
Figure 4-9
Instead of the nut and threaded spindle shown in the diagram, other types of equipment
such as hydraulic lifting equipment may be used.
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft extensions
and flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Please contact
Technical Support if you notice any damage.
3. Apply the mounting paste ⑦ to the machine shaft ①. Apply the paste uniformly.
4. Fit the gearbox using the disk ⑤, threaded spindle ④ and nut ③. Support is provided by the
hollow shaft ②.
5. Replace the nut ③ and the threaded spindle ④ with a screw. Tighten the bolts to the
specified torque.
You have mounted the hollow shaft with splined shaft.
Table 4- 9
Thread size
Tightening torque [Nm]
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
Not included in the scope of supply
Machine shaft
Hollow shaft
Hexagon nut
Threaded spindle
Disk
Locking ring
Mounting paste
Mounting the hollow shaft with splines
Tightening torque for the screw
M5
5
4.9 Installing and removing the shaft-mounted gearbox
M6
M8
M10
M12
8
8
14
24
Installation
M16
M20
M24
M30
60
120
200
400
43
Advertisement
Table of Contents
