SET‑UP
Unpacking and setting up the vehicle
2.1
–
Remove the box and the plastic packaging.
–
Check the vehicle for transport damage.
–
Remove the vehicle from the palette.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
–
Remove the rear fender. (
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
200151-10
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-
ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Observe the instructions in the separate enclosure of the battery.
–
Recharge the battery. (
–
Install the battery. (
–
Fill up with fuel. (
–
Insert the ignition key
Info
The key cover cap is in the tool set.
Read the installation instructions on the inside of the cap.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.
100107-10
p. 5)
p. 6)
p. 7)
p. 8)
in the key cover cap
.
3