Adjusting The High Pass Filter; Using A Subwoofer; Adjusting The Low Pass Filter - Denon HEOS Super Link Owner's Manual

Contents

Adjusting the high pass filter

Set the High Pass Filter to limit the low frequency signal being sent to your
speakers.
1
Select "High Pass Filter".
2
Select the frequency cutoff point:
Off / 40 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /
200 Hz / 250 Hz
0 If you enable the IP control, "High Pass Filter" will be disappeared and forced to
change.
Setup Use Troubleshooting

Using a subwoofer

1
Select "Subwoofer".
2
Enable the Sub Out (L) setting.
0 If you enable the IP control, "Subwoofer" will be disappeared and forced to
change.

Adjusting the Low Pass Filter

When Subwoofer is set to on, you can limit the high frequency signal being
sent to your subwoofer.
1
Select "Subwoofer".
2
Select "Low Pass Filter".
3
Set the frequency cutoff point.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz
42
Status LED Appendix