Resetting Your Heos Device - Denon HEOS Super Link Owner's Manual

Contents

Resetting your HEOS device

Resetting your HEOS device will clear out EQ, and name but retain it's current software. To reset your HEOS Super Link, press
the Reset button on the back and hold it in until the Zone LED begins to flash amber.
Restoring the HEOS device to factory defaults
Restoring the HEOS device to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
0
To restore your HEOS Super Link to the factory defaults, turn off the power switch of rear panel. Press the Reset button on the
back, turn on the power switch of rear panel, and hold it in until the Zone LED begins to flash amber.
* For further information, please visit http://www.HEOSbyDenon.com
Setup Use
Solution
Solution
Troubleshooting
52
Status LED Appendix
Refer to Page
Refer to Page
–
–