Starting The Setup - Yamaha htr-5890 Owner's Manual

Starting the setup

For best results, make sure the room is as quiet as possible
during the auto setup procedure (YPAO). If there is too
much ambient noise, the results may not be satisfactory.
y
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and
set the crossover frequency to the maximum.
VOLUME
MIN MAX
Subwoofer
1
Switch on this unit and video monitor.
Make sure the OSD is displayed (see page 50).
2
Set AMP/SOURCE/TV to AMP, then press
SET MENU to enter the SET MENU.
AMP
then
SOURCE
TV
3
Press k / n to select AUTO SETUP, then
press h once to enter the main menu.
SET MENU
. ;AUTO SETUP
;MANUAL SETUP
/
< / >
CROSSOVER/
HIGH CUT
MIN MAX
SET MENU
MENU
ENTER
: Up/Down
: Enter
ENTER
4
Press k / n repeatedly to select WIRING,
DISTANCE, SIZE, EQUALIZING or LEVEL.
1 AUTO:MENU
. WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
EQUALIZING;;FLAT
LEVEL;;;;;;CHECK
SETUP;;;;;;;AUTO
START PUSH
/
< / >
5
When WIRING, DISTANCE, SIZE or LEVEL is
selected, press l / h to select:
CHECK To automatically check and adjust the selected
item.
SKIP To skip the selected item and perform no
.
adjustments
Note
When using THX speakers, set SIZE to SKIP and make sure
that "SMALL" or "SMLx2" is selected in SPEAKER SET
(page 55) and that 80Hz (THX) is selected in CROSS
OVER (page 57).
When EQUALIZING is selected, press l / h
to select:
To adjust the frequency response of
FRONT
each speaker in accordance with the
sound of your front speakers.
Recommended if your front speakers
are of much higher quality than your
other speakers.
To average the frequency response of
FLAT
all speakers. Recommended if all of
your speakers are of similar quality.
To average the frequency response of
LOW
all speakers, giving priority to the
accuracy of bass frequencies.
To average the frequency response of
MID
all speakers, giving priority to the
accuracy of mid-range frequencies.
To average the frequency response of
HIGH
all speakers, giving priority to the
accuracy of high frequencies.
To skip the selected item and perform
SKIP
no adjustments.
6
Press n to select SETUP, then press l / h to
select:
To automatically perform the entire
AUTO
auto setup procedure.
To pause for confirmation between
STEP
each check in the auto setup procedure.
To restore the last auto setup setting.
RELOAD
AUTO SETUP
>
: Up/Down
: Select
27