Starting The Setup - Yamaha RX-V750 Owner's Manual

Starting the setup

For best results, make sure the room is as quiet as possible
during the auto setup procedure. If there is too much
ambient noise, the results may not be satisfactory.
y
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and
set the crossover frequency to the maximum.
1
Switch on this unit and your video monitor.
Make sure the OSD is displayed.
2
Press AMP.
3
Press SET MENU.
4
Press u / d to select AUTO SETUP.
+
TV VOL
CH CH
TV MUTE
– +
SELECT
PRESET PRESET
TV VOL
–
5
Press SELECT to enter AUTO SETUP.
CH
–
PRESET
AMP
SET MENU
MENU
A/B/C/D/E
SET MENU
. ;AUTO SETUP
;MANUAL SETUP
/ : Up/Down
SELECT : Select
+
TV VOL
CH
TV MUTE
+
SELECT
PRESET
TV VOL
–
6
Press u / d
to select the desired parameter,
then press j / i
to select the desired
1 AUTO SETUP
. WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
SWFR;;;;;;;SKIP
SETUP......AUTO
START PUSH SELECT
/ : Up/Down
- / + : Change
WIRING/LEVEL
DISTANCE/PHASE
SIZE
SW PHASE
CHECK
To automatically check and adjust the selected
item.
SKIP
To skip the selected item and perform no
adjustments.
SETUP
AUTO
To automatically perform the entire
auto setup procedure.
STEP
To pause for confirmation between
each check in the auto setup procedure.
RELOAD
To restore the last auto setup setting.
7
Press d to select START PUSH SELECT,
then press SELECT.
Loud test tones will be output from each speaker in
turn and WAIT appears during the auto setup
procedure.
1 AUTO SETUP
. WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
SWFR;;;;;;;SKIP
SETUP......AUTO
START PUSH SELECT
/ : Up/Down
- / + : Change
Note
If E-10:OTHER ERROR appears during testing, restart the
procedure from step 3.
AUTO SETUP
setting.
27