Yamaha htr-5890 Owner's Manual page 33

Troubleshooting for auto setup procedure
Before auto setup
Error message
Connect MIC!
Unplug HP!
During auto setup
Press l / h to display the detailed information about individual errors. Select "RETRY" to try auto setup procedure
again.
Error message
E-1:NO FRONT SP
E-2:NO SURR.SP
E-3:NO PRES. SP
E-4:SBR->SBL
E-5:NOISY
E-6:CHECK SURR.
E-7:NO MIC
E-8:NO SIGNAL
E-9:USER CANCEL
E-10:OTHER ERROR
Cause
Optimizer microphone is not connected.
Headphones are connected.
Cause
Front L/R channel signal(s) is (are) not
detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only right surround back channel signal is
detected.
Background noise is too loud.
Surround back speaker(s) is (are) connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the auto setup procedure.
The optimizer microphone does not detect test
tones.
The auto setup procedure was cancelled due to
user activity.
An internal error occurred.
Remedy
• Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
• Unplug the headphones.
Remedy
• Select the front speakers with SPEAKER A or B.
• Check the front L/R speaker connections.
• Check the surround speaker connections.
• Check the presence speaker connections.
• Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
• Try auto setup procedure in a quiet environment.
• Turn off noisy electric equipment like air conditioners
(etc.) or move them away from the optimizer
microphone.
• Connect surround speakers when you use (a)
surround back speaker(s).
• Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the front panel.
• Check the microphone setting.
• Check the speaker connections and placement.
• Perform the auto setup procedure again.
• Perform the auto setup procedure again.
AUTO SETUP
29