Optimizing The Speaker Setting For Your Listening Room; Before Starting The Automatic Setup; Quick Automatic Setup - Yamaha RX-V3900 Owner's Manual

Optimizing the speaker setting for your listening room

This unit employs the YPAO (Yamaha Parametric room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
This unit is equipped with various automatic setup features. You can select the automatic setup features according to your
preference.
Quick automatic setup (page 30)
Use this feature to carry out the automatic setup without using the GUI screen.
Basic automatic setup (page 31)
Use this feature to optimize the setup of this unit for one listening position. You can also select the parameters to be
optimized by the automatic setup.
Advanced automatic setup (page 33)
Use this feature to optimize the setup of this unit for multiple listening positions. You can also select the parameters to be
optimized by the automatic setup.
Before starting the automatic
setup
Make sure of the following check points before
starting the automatic setup operations.
❏
Speakers are connected appropriately.
❏
Headphones are disconnected from this unit.
❏
This unit is turned on.
❏
The connected subwoofer is turned on and the
volume level is set to about half way (or slightly
less).
❏
The crossover frequency controls of the
connected subwoofer is set to the maximum.
VOLUME
MIN MAX
Controls of a subwoofer (example)
❏
The room is sufficiently quiet.
❏
Set the operation mode selector on the remote
control to FAMP.
Notes
• Be advised that it is normal for loud test tones to be output
during the automatic setup procedure.
• To achieve the best results, make sure the room is as quiet as
possible while the automatic setup procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.
30
En
CROSSOVER
HIGH CUT
MIN MAX

Quick automatic setup

Use this feature to carry out the automatic setup without
using the GUI screen.
1
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
AUDIO SELECT/ TONE
REC OUT MENU CONTROL ENTER PRESET/TUNING
STRAIGHT
EFFECT
YPAO SILENT CINEMA S VIDEO
PROGRAM OPTIMIZER
MIC PHONES
The following screen appears in the front panel
display.
A U T O S E T U P
E N T E R T O S T A R T
Note
"View GUI Menu" appears if the GUI menu screen is
turned on. In this case, press IMENU to turn off the GUI
menu screen or follow "Basic automatic setup" (page 31).
2
Place the optimizer microphone at your
normal listening position on a flat level
surface with the omni-directional
microphone heading upward.
SEARCH STEREO/
MEMORY MODE MONO BAND INFO
ZONE ON/OFF ZONE CONTROLS
MULTI ZONE
ZONE 2 ZONE 3
VIDEO L AUDIO R OPTICAL
VIDEO AUX USB
Omni-directional
microphone