Yamaha htr-5890 Owner's Manual page 34

AUTO SETUP
After auto setup
Press l / h to display the detailed information about individual warnings.
Warning message
W-1:OUT OF PHASE
W-2:OVER 24m
(80ft)
W-3:LEVEL ERROR
W-4:SWFR PHASE
W-5:VOL ERROR
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again.
• If warning W-1, W-4 or W-5 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
30
Cause
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
The distance between the speaker and the
listening position is over 24 m (80 ft).
The difference of volume level among speakers
is excessive. (No level correction is made.)
The phase polarity of the subwoofer is not
correct.
The result may not be correct because the
volume was changed during the auto setup
procedure.
Remedy
• Check the speaker connections for proper polarity
(+ or –).
• Bring the speaker closer to the listening position.
• Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
• Check the speaker connections.
• Use speakers of similar quality.
• Adjust the output volume of the subwoofer.
• Select the opposite phase on the subwoofer if the
subwoofer has a phase switch.
• Perform the auto setup procedure again. Do not
change the volume during the auto setup procedure.