Ricoh Priport JP5000 Operating Instructions Manual page 190

What to do If Something Goes Wrong
Message
Papers are left on the
delivery tray
Please remove
Please put up side/
end plates on the de-
livery tray
Over loaded for the
delivery tray
5
Please remove the pa-
per
Print image is larger
than the selected pa-
per size.
Change the paper
size.
Cannot sort thick pa-
pers
170
Meaning
Remove the paper from the delivery tray, or make the master
and prints using the same paper as the previously used one.
Note
You can eliminate this message by pressing the [Exit] key.
However, this message will be displayed again when mak-
ing the master or prints if you do not remove the paper.
The paper delivery side or end plate is lowered.
Lift the paper delivery side or end plate.
Note
If you press the [Exit] key to dismiss the message and press
the {Start} key or {Print} key, the machine starts to make the
master or prints. However, the prints might not be aligned.
Remove the paper from the delivery tray.
Reference
See "Delivery Capacity" ⇒ P.139 "2. Set Operation Mode".
The master image previously printed is larger than the paper,
the image overflows the paper size.
Make prints again after pressing the [Exit] key and selecting
the paper size again.
Note
If you press the [Exit] key to dismiss the message and press
the {Print} key, the machine starts to make the prints. How-
ever, the image might not fit on the paper.
The paper type is set as the "Thick" or "Special".
Press the [Exit] key to dismiss the message and select the paper
type except Thick and Special.
If you cannot change the paper type, press the [Exit] key to dis-
miss the message and disable sorter mode.
Note
If you press the [Exit] the message will be dismissed, but it
will be displayed again when making the master or prints.