Ricoh Priport JP5000 Operating Instructions Manual page 165

No. Mode
15 Deflector Angle You can change the angle of the wing guide depending on
16 Auto Class
17 Auto Separate
18 Ink/Master
Left
Description
the paper type you use.
Note
Default: Auto
Available settings:
• Up (Select this setting when standard thickness or
thin paper misfeeds at the paper exit section occur
frequently.)
• Down (Select this setting when A4 – B5, 8
thick paper is not delivered properly to the paper de-
livery tray.)
When you do not use the Job Separation function, you can
select the machine's condition after each printing set is fed
out to the paper delivery tray.
Note
Default: Stop
Available settings:
• Start printing automatically (After the last page of
each printing set is fed out to the paper delivery tray,
the machine stops for a few seconds. Then, the next
cycle begins.)
• Stop (After the last page of each printing set is fed
out to the paper delivery tray, the machine stops. If
you press the {Print} key, the next cycle begins.)
Specifies whether Job Separation mode is automatically
carried out when you make prints in All Class, Auto Class,
Manual Class, or Class mode.
Note
Default: ON
Specifies whether you can check the amount of ink and
master.
Note
Default: OFF
Available settings:
• OFF (You cannot check the remaining amount of ink
or master.)
• ON (When the remaining amount of ink or master is
less than half, the panel display indicates these
amounts when you turn on the main switch.)
• Check remaining volume (You can see the remaining
amounts of ink and master regardless of these
amounts.)
User Tools Menu
" × 11"
1
/
2
4
145