Table of Contents
Advertisement
9.
Secure the top link assembly to the axle support
with a screw (1/2 x 3-1/4 inches), 2 support
washers, spacer, and a locknut (1/2 inch) as
shown in
Figure 5
Note:
The washers are to be positioned on the
outside of the ears on the axle support.
7).
1. Locknut (1/2 inch)
2. Spacer
10.
Torque the screw to 91 to 113 N⋅m (67 to 83
ft-lb).
and
Figure
6.
Figure 7
3. Support washer
4. Screw (1/2 x 3-1/4 inches)
4
Installing the Hydraulic
Figure
Tube Assemblies
Parts needed for this procedure:
1
Tube clamp
1
Plate
1
Tube clamp
1
Plate
2
Carriage screw
2
Flange nut
Procedure
1.
Place a drain pan under the caps on the
hydraulic tubes
g015950
2.
Remove the caps from the hydraulic tubes on
the machine
a time as installing the tubes to prevent excess
hydraulic fluid loss.
1. Hydraulic tube caps
6
(Figure
8).
(Figure
8). Remove the caps one at
Figure 8
g015520
Advertisement
Table of Contents
