Table of Contents
Advertisement
3
Mounting the Front
Attachment Frame
Parts needed for this procedure:
4
Screw (1/2 x 1-1/4 inches)
11
Flange nut (1/2 inch)
6
Screw (1/2 x 4-1/2 inches)
4
Spacer
1
Screw (1/2 x 3-1/4 inch)
2
Support washer
1
Spacer
Procedure
1.
Figure 5
shows the top view of the location,
positioning, and size of the fasteners used
to secure the front attachment frame to the
underside of the traction unit frame.
1. Front attachment frame
2. Screw (1/2 x 1-1/4 inches)
and flange nut (1/2 inch)
3. Screw (1/2 x 4-1/2 inches)
4. Spacer
2.
Guide the shorter hydraulic tube assembly
(Figure
4) around and above the traction control
rod.
Figure 5
5. Screw (1/2 x 3–1/4
inches), support washers,
and locknut (1/2 inch)
6. Lock pin
7. Hair pin cotter
3.
Position the front attachment frame under the
front of the machine
4.
Raise the front attachment frame while aligning
the mounting holes with the mounting holes in
the frame channels and the front frame cross
plate
(Figure
1. Screw (1/2 x 1-1/4 inches)
and flange nut (1/2 inch)
2. Screw (1/2 x 4-1/2 inches)
and flange nut (1/2 inch)
5.
On the front of the attachment, secure the outer
hole, on each side, to the frame channels with a
screw (1/2 x 4-1/2 inches) and a flange nut (1/2
inch) as shown
6.
On the rear of the attachment, loosely install
each side to the frame channels with 2 screws
(1/2 x 1-1/4 inches) and flange nuts (1/2 inch) as
shown
inFigure
7.
Using the remaining 4 mounting holes, secure
the attachment to the frame cross plate with
screws (1/2 x 4-1/2 inches), spacers, and flange
nuts (1/2 inch) as shown
g015496
the spacers between the screw head and the
cross plate.
8.
Tighten the fasteners to 91 to 113 N⋅m (67 to
83 ft-lb).
5
(Figure
6).
6).
Figure 6
3. Screw (1/2 x 4-1/2 inches),
spacer, and flange nut (1/2
inch)
4. Screw (1/2 x 3-1/4 inches),
support washers, and
locknut (1/2 inch)
inFigure
6.
6.
inFigure
6). Position
g015497
Advertisement
Table of Contents
