When Having Some Trouble - Yamaha LPX-510 Owner's Manual

When Having Some Trouble

The projector is provided with the following three
indicators which notify you of the operating status of the
projector. The following tables show what the indicators
mean and how to remedy the problems that they indicate.
*If the indicator does not light when the power is
turned on, the power cord may not be connected correctly
or the power may not be supplied.
The following tables show what the indicators mean and how to remedy problems that they indicate.
Indicator status
Red Red
LAMP/COVER TEMP/FAN
Red
LAMP/COVER TEMP/FAN
Red Red
LAMP/COVER TEMP/FAN
Red Red
LAMP/COVER TEMP/FAN
Red
LAMP/COVER TEMP/FAN
LAMP/COVER TEMP/FAN
Orange
LAMP/COVER TEMP/FAN
42
Projector status
Internal problem Stop using the projector, disconnect the power cord from the
Red
electrical outlet, and contact your dealer.
Fan problem/Sensor Stop using the projector, disconnect the power cord from the
Red
problem electrical outlet, and contact your dealer.
Lamp problem/ Check if the lamp is broken or if the lamp cover is not securely
Lamp cover is open installed. If the lamp is not broken, reinstall it and then turn the
error power back on.
If the indicators still show a problem, stop using the projector,
turn off the main power switch, disconnect the power cord from
the electrical outlet, and contact your dealer.
If the lamp is broken, contact your dealer to request the lamp to
be replaced.
Lamp operating Check if the lamp is broken or if the lamp cover is not securely
error installed. If the lamp is not broken, reinstall it and then turn the
power back on.
If the indicators still show a problem, stop using the projector,
turn off the main power switch, disconnect the power cord from
the electrical outlet, and contact your dealer.
If the lamp is broken, contact your dealer to request the lamp to
be replaced.
High temperature The lamp will turn off automatically and projection will stop.
Red
inside projector Wait for about 5 minutes without operating the projector.
• • • •
(overheating)
• • • •
If the problem is not solved when the power is turned back on,
stop using the projector, turn off the main power switch,
disconnect the power cord from the electrical outlet, and contact
your dealer.
High-speed cooling (No abnormality)
Orange
in progress
Projection can continue, but if the temperature rises too high
again, projection will stop automatically.
Carry out the same steps as for "High temperature inside
projector".
The appearance of the
depending on the status of the projector.
Lamp will soon need (No abnormality)
to be replaced. It is time to replace the lamp. Replace the lamp with a spare one
as soon as possible.
If you continue to use the old lamp, there is the danger that it
may break.
The appearance of the
depending on the status of the projector.
STANDBY/ON
ESCAPE
PATTERN
ASPECT
LAMP/COVER TEMP/FAN
Problem and remedy
If the projector is set up near a wall, leave a space of at least 20
cm between the wall and the projector.
If the air filter is blocked, it should be cleaned.
indicator at this time will vary
indicator at this time will vary
indicator
MENU
SETTING
LAMP/COVER indicator
INPUT
TEMP/FAN indicator
: lit : flashing
Reference
page
"Setup
Guide"
"Setup
Guide"
: off
p.53
p.53
p.51
p.51
p.53