Bosch Climate 5000 Series Service Manual page 77

Service Manual
4. Disconnect the connector for fan motor from the electronic control board.
Figure 87
5. Remove the four af xing screws of the fan motor. Then remove the fan motor.
Figure 88
Bosch Thermotechnology Corp. | 04.2020
Bosch Climate 5000 Series Ductless Air Conditioner / Heat Pump Outdoor Unit | 77
9.2.3 Removing the electrical parts
1. After removing the panel plate and fan assembly, remove the connectors for
the compressor.
Figure 89
2. Pull out the two blue wires connected with the reversing valve.
Figure 90
3. Pull out connectors of the condenser coil temp. sensor (T3), outdoor
ambient temp. sensor (T4) and discharge temp. sensor (T5).
Figure 91
Data subject to change