System - Yamaha RM1x Owner's Manual

1. System

1. System
Here you can make settings for system-related parameters, such as Master Tune.
page1
Parameter
Master tune
Footswitch
Pattern Quantize
Memory Protect on/off
* For information about how to change values, refer to the Basic Operation (page26).
[Footswitch function list]
START/STP Each time the footswitch is pressed, the song or pattern will alternately start or stop.
SEC Each time the footswitch is pressed, the Section of the pattern will be switched in the order of A - P.
SUS All notes played while the footswitch is held will be sustained until the footswitch is released.
TAP This useful function lets you use the footswitch to tap out the BPM (Tempo) . Simply tap (press/release) the footswitch three
times, and the song or pattern starts automatically at the BPM you tapped. The BPM can also be changed during playback
by tapping the footswitch three times at the desired tempo.
132
RM1x SEQUENCE REMIXER
Values
-102.4 ... 0 ... +102.3
START/STP, SEC, SUS, TAP
1, 1/16
ON, OFF
Function
Sets the overall tuning of the entire RM1x in 0.1 cent steps.
The pitch of drum voices cannot be adjusted here.
One cent is 1/100th of a semitone.
Sets the function of the footswitch connected to the rear panel FOOT
SW connector.
For details, see the list below.
Sets the quantize value for pattern switching during playback. When
set to "1" patterns (sections) will always switch on the first beat of
the measure during playback. When "1/16" is selected patterns (sec-
tions) can be switched on any 16th beat during playback.
Turns memory protection on or off. When "ON" no operations which
alter or overwrite the contents of the RM1x memory can be per-
formed (e.g. record or edit or job), preventing accidental changes to
the memory or tampering.