Yamaha RM1x Owner's Manual page 86

12. Job
1. Phrase setting: Phrs
Sets the phrase to which adjustment is applied.
Settings : 001 ... 256
2. Segment (M001:1:000 ~ M257: 1:000)
Sets the area of the phrase over which adjustment is
carried out. The first segment sets the measure, beat,
and clock for the start point; the second segment sets
the end point.
Settings : Measure: beat : clock
001:1:000 ... 257:1:000
3. Set all
Use this parameter if you want to set all targeted notes
to some identical gate time (1 to 9999). If you do not
want to use this feature (if you want to make the linear
adjustment instead), set the value to Off.
Note that if the setting is other than Off, the Rate and
Offset values are ignored.
Settings: Off (0), 0001 ... 9999
4. Rate
The Rate parameter applies a proportional change to
the gate timing of all targeted notes. A setting of 100%
produces no change; a setting of 50% cuts the gate time
in half; a setting of 200% causes the gate time to dou-
ble.
Settings: 000% ... 100% ... 200%
Original gate timing
(Gate)
32 32
Rate = 50%
(Gate)
16 16
Rate = 150%
(Gate)
48 48
86
RM1x SEQUENCE REMIXER
32 48 48
16 24 24
48 72 72
5. Offset
This parameter adds a fixed value to each of the Rate-
adjusted gate times. A setting of 0 produces no change.
Positive values increase the gate time, while negative
values decrease it.
Settings: -9999 ... +0000 ... +9999
Original gate timing
(Gate)
32 32 32
Offset = -20
(Gate)
12 12 12
Offset = +20
(Gate)
52 52 52
Job 04 Crescendo
1
You use this job to apply a crescendo or decrescendo to the
specified range of notes (pitches) in the specified segment of
the designated track. The RM1x produces the effect by apply-
ing a slight velocity adjustment (offset) at the beginning of
the segment, with the offset increasing gradually up until the
end of the segment.
1. Phrase setting: Phrs
Sets the phrase to which adjustment is applied.
Settings : 001 ... 256
2. Segment (M001:1:000 ~ M257: 1:000)
Sets the area of the phrase over which adjustment is
carried out. The first segment sets the measure, beat,
and clock for the start point; the second segment sets
the end point.
Settings : Measure: beat : clock
001:1:000 ... 257:1:000
3. Velocity Range
You use the Velocity Range parameter to set the inten-
sity of the crescendo.
This setting selects the value added to the velocities of
notes at the final meter and beat of the segment. The
RM1x gradually increases the amount added to (or sub-
48 48
28 28
68 68
2
3