Yamaha DM2000 Owner's Manual page 325

MULTI FILTER
Two input, two output 3-band multi-filter (24 dB/octave).
Parameter Range
TYPE 1 HPF, LPF, BPF
TYPE 2 HPF, LPF, BPF
TYPE 3 HPF, LPF, BPF
FREQ. 1 28.0 Hz–16.0 kHz
FREQ. 2 28.0 Hz–16.0 kHz
FREQ. 3 28.0 Hz–16.0 kHz
LEVEL 1 0–100
LEVEL 2 0–100
LEVEL 3 0–100
RESO. 1 0–20
RESO. 2 0–20
RESO. 3 0–20
FREEZE
One input, one output basic sampler.
Parameter Range
REC MODE MANUAL, INPUT
REC DLY –1000 to +1000 ms
TRG LVL –60 to 0 dB
TRG MASK 0–1000 ms
MOMENT, CONTI.,
PLY MODE
INPUT
1
START
END 1
LOOP 1
LOOP
0–100
NUM
START
0–262000
[SAMPLE]
END
0–262000
[SAMPLE]
LOOP
0–262000
[SAMPLE]
PITCH –12 to +12 semitones
FINE –50 to +50 cents
MIDI TRG OFF, C1–C6, ALL
1. 0.0–5941.0 ms (fs=44.1 kHz), 0.0 ms–5458.3 ms (fs=48 kHz), 0.0–2970.5 ms (fs=88.2 kHz),
0.0 ms–2729.2 ms (fs=96 kHz)
Description
Filter 1 type: high pass, low pass, band pass
Filter 2 type: high pass, low pass, band pass
Filter 3 type: high pass, low pass, band pass
Filter 1 frequency
Filter 2 frequency
Filter 3 frequency
Filter 1 level
Filter 2 level
Filter 3 level
Filter 1 resonance
Filter 2 resonance
Filter 3 resonance
Description
In MANUAL mode, recording is started by pressing the REC and
PLAY buttons. In INPUT mode, Record-Ready mode is engaged by
pressing the REC button, and actual recording is triggered by the
input signal.
Recording delay. For plus values, recording starts after the trigger is
received. For minus values, recording starts before the trigger is
received.
Input trigger level (i.e., the signal level required to trigger recording
or playback)
Once playback has been triggered, subsequent triggers are ignored
for the duration of the TRG MASK time.
In MOMENT mode, the sample plays only while the that the PLAY
button is pressed. In CONT mode, playback continues once the
PLAY button has been pressed. The number of times the sample
plays is set using the LOOP NUM parameter. In INPUT mode, play-
back is triggered by the input signal.
Playback start point in milliseconds
Playback end point in milliseconds
Loop start point in milliseconds
Number of times the sample plays
Playback start point in samples
Playback end point in samples
Loop start point in samples
Playback pitch shift
Playback pitch shift fine
PLAY button can be triggered by using MIDI Note on/off messages.
325
Effects Parameters
DM2000—Owner's Manual