Disconnecting The Cable - Wasp WDI4700 Quick Reference Manual

Setting Up the Reader

Disconnecting the Cable

To remove the interface cable from the reader, first locate
the hole on the back of the handle. Next, take a paper clip
and modify it as shown in the figure below. Insert the end
of the paper clip into the hole and press it to push on the
clip that holds the connector. As you apply pressure, pull
out the cable.
When reinserting the cable, make sure the connector clip is
on the same side as the reader release hole. Insert the
cable, it should click when it is fully inserted.
4 Wasp WDI4700