Configuring The Interface - Wasp WDI4700 Quick Reference Manual

Selecting the Interface Type
Information and programming options for each interface
type are provided in this section. For defaults and addi-
tional information associated with each interface, proceed
to the corresponding chapter in the Wasp WDI4700 PRG.

Configuring the Interface

Scan the appropriate programming bar code to select the
interface type for your system.
NOTE
RS-232
8
Unlike some other programming features and
options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan-
ning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while in
this state, pull the trigger and hold for 5 seconds.
The scanner will change to a state that allows
programming with bar codes.
RS-232 standard interface
Select RS232-STD
RS-232 Wincor-Nixdorf
Select RS232-WN
Wasp WDI4700