Disconnecting The Cable; Using The Wasp Wdi9600; Aiming System - Wasp WDI9600 Quick Reference Manual

Disconnecting the Cable

DISCONNECTING THE CABLE
To remove the interface cable from the reader, first locate
the hole on the back of the handle. Next, take a paper clip
and modify it as shown in the figure below. Insert the
end of the paper clip into the hole and press it to push on
the clip that holds the connector. As you apply pressure,
pull out the cable. When reinserting the cable, make sure
the connector clip is on the same side as the reader
release hole. Insert the cable, it should click when it is
fully inserted.
NOTE: We recommend the use of a perfectly
straight new staple to make the operation easier
(see the pictures below).

USING THE Wasp WDI9600

The Wasp WDI9600 normally functions by capturing and
decoding codes. The reader is equipped with an internal
Motionix™ motion-sensing function which activates the
aiming system on device motion. The intelligent aiming
system indicates the field of view which should be
positioned over the bar code:

Aiming System

4
Wasp WDI9600
www.waspbarcode.com