Changing Password; Changing Basic Settings - Siemens SITRANS FM MAG 5000 Operating Instructions Manual

Commissioning

6.5 Changing basic settings

6.4

Changing password

The setup menu is password-protected in order to ensure that only authorized personnel can
make any changes in transmitter settings.
Change password as follows:
1. Press top up key
2. Enter password.
3. Use forward key
4. Press lock/unlock key
5. Use select key
6. Press lock/unlock key
7. Press top up key
The factory-set password is 1000, but it can be changed to any value between 1000 and 9999.
Factory setting of password can be re-established as follows:
1. Switch off power supply.
2. While pressing top up key
3. Release top up key
6.5 Changing basic settings
In the basic settings menu it is possible to set the following parameters:
Parameter
Main frequency
Flow direction
Customer units
Q
max
Q
max
Totalizer
44
for 2 sec.
or backward key
and change key
two times to exit setup mode.
after 10 sec.
Description
Selection of main power supply frequency corresponding to the country in which
the flowmeter is installed (e.g. 60 Hz in America).
Selection of correct flow direction in pipe.
Setting of user defined volume and time units.
Setting of measuring range, analog outputs and frequency output. Also individ‐
ual dimension-dependent setting of value, decimal point, unit and time.
2 Setting of measuring range, analog outputs and frequency output. Also individ‐
ual dimension-dependent setting of value, decimal point, unit and time. This
menu is only visible if chosen as external digital input.
Setting of unit and decimal point.
to reach password menu.
to unlock password.
to change password.
to confirm new password.
- switch on power supply.
SITRANS FM MAG 5000/6000 IP67
Operating Instructions, 12/2019, A5E02338368-AD