SATO SG112 ex Programming Reference Manual page 510

Connector Pin Assignment
14 pin external signal interface
Pin Signal name
no.
1 PAPER END
2 GND
3 RIBBON END Output when detect
4 MACHINE
ERROR
5 Print start
(PRIN)
6 Print end
*1 *2
(PREND)
7 Re-print
(PRIN2)
8 EXT5V_IN
9 Offline
10 RIBBON
NEAR END
11 -
12 +24V
13 +5V
14 -
*1 Select TYPE I-TYPE IV for No.6 pin "PREND" output signal. For details, refer to external signal type in Basic specification.
*2 No. 6 pin "PREND" output signal is not output when "0" is specified as number of cuts for cut unit number command in
cutter operation.
*3 When SW4 on CONT board is set to EX, the printer operates by power supply from EXT5V_IN (No. 8 pin). When JP1 is set
to INS side, Operation is done by internal power supply.
*4 When SW3 on CONT board is set to EXO6, the no.9 pin operates as offline output. If it is set to EXI side, it operates as
input.
Contents
Output when paper Output
end is detected.
SIGNAL GROUND -
Output
ribbon end.
Output when Head Output
open, Head error
or communication
error occurs.
Print one label Input
every time when
this signal is input.
Output when this Output
product prints one
label.
Print the same Input
content again by
input this signal.
For external power Input
supply
Output when this Output
product becomes
offline.
Output when Output
detecting ribbon is
near end.
- -
- -
- -
- -
509
Input/Output Level
Low
-
High
Low
Low
Low
Low
-
Low
Low
-
-
-
-
Electric condition
(voltage, current (MAX))
5 V
400 mA
-
5 V
400 mA
5V
400 mA
High: Hi-impedance
Low: -15 mA<, 0 V
5 V
400 mA
High: Hi-impedance
Low: -15 mA<, 0 V
5 V
5 V
400 mA
5 V
400 mA
-
2A
500 mA
-