Table of Contents
Advertisement
ERROR
DETECTION
*1 Print quantity may not be set properly depending on timing of edit and analysis.
*2 BUFFER OVER may occur or may not occur, it depends on interface.
RS-232C: BUFFER OVER may occur.
USB, LAN, IEEE1284: BUFFER OVER may not occur.
Cancel Request Command
This command enables to cancel print jobs and to clear the entire contents of receive buffer.
The status of this product after finishing process is returned.
* When the cancel request command has been sent, wait more than 500 ms before sending the next data.
* This command shall not be used while sending other data like print data.
1. Command CAN (HEX 18H)
2. Return status list
Return status
ACK (HEX 06H)
NAK (HEX 15H)
Print Command
Print starts after receiving print command (STX <A> to <Z> ETX).
The status of this product after receiving command is returned.
1. Return status list (The status of this product)
Return status
ACK (HEX 06H)
NAK (HEX 15H)
Command example of Job ID number <ID>
<A>
<ID>01
<V>100<H>100<P>2<L>0202<XM>ABC
<Q>1
<Z>
Please refer to "Job ID Number <ID>" in this document for details.
Contents
RIBBON NEAR END & BUFFER NEAR FULL
*2
BUFFER OVER
HEAD OPEN
PAPER END
RIBBON END
MEDIA ERROR (PRINT ERROR)
SENSOR ERROR
HEAD ERROR
CARD ERROR
OTHER ERRORS
No error in this product
Error in this product
No error in this product
Error in this product
414
*1
Contents
Contents
ASCII
HEX
V
56
a
61
b
62
c
63
d
64
e
65
f
66
g
67
i
69
k
6B
Advertisement
Table of Contents
