Table of Contents
Advertisement
[Supplementary Explanation]
-
This command supports UPC-A only. When barcode type is specified other than "H," command
error occurs.
-
HRI is printed only when the narrow bar width is specified with 03 or 04.
HRI will not be printed if the value other than the listed above is specified.
-
Setting of Guard bar, HRI and ratio is described as follows.
Guard bar: Available
HRI: Available
Ratio: Fix
-
When the parameter value exceeds the range, operation is not supported.
-
When printing UPC-A with <BD>, all character barcodes have the same height. When <BM>
is used, the height of the character barcode of the start digit and the last digit have the same
height of the guard bar. When printing UPC-A with <BD>, HRI can be printed under the first
digit and the last digit because the height of the first digit and the last digit of the barcode is
low. When printing UPC-A specifying <BM>, the height of the first digit and the last digit of the
barcode is high, and the font interval is narrower than previous case.
UPC-A specifying <BD>
UPC-A specifying <BM>
202
Advertisement
Table of Contents
