Error Messages From Downstream Devices - GBC 16 Series User Manual

Error Messages
From downstream devices
The following is a listing of error messages that could appear on the
FusionPunch II Control Panel Display screen genereted by a downstream
device. Also included are a description of the possible causes and the
resolution for each problem.
These messages will only be displayed when the FusionPunch II is
Note:
set up in
make sure that the downstream device is turned on and that the
communications cable (DFA Cable) is properly connected.
Error Message
Next Device
Not Ready
Next Device Faulted
Next Device Full
Figure 3-5: Downstream device - Generated Error Messages
Error Messages
mode. If all messages are displayed one after the other,
Possible Cause
The downstream
device from the
FusionPunch II is not
ready to receive paper.
The downstream
device from the
FusionPunch II is in a
Fault condition and is
is not ready to receive
paper.
The downstream
device from the
FusionPunch II is in a
Full condition and is
not ready to receive
paper.
Resolution
Check the downstream
device for further
information.
Check the downstream
device for further
information and fault-
resolutions.
Check the downstream
device for further
information.
3
3-13