Table of Contents
Advertisement
Setting the Backgauge
The purpose of this procedure is to ensure that the margin between the
leading edge of the copy and the punched holes is correct.
1
If your die set is anything
Backgauge Adjustment Knob clockwise continuously until it stops. If
your die set
2
Check the margin between the leading edge and the punched holes of
copies that have been run through the Punch, or, from paper you have
run through the Manual Feed Tray. If the margin is correct, go to
of the FusionPunch II. If the margin is not correct, go to
adjust the Backgauge.
2-12
a
die set, go to
in this chapter to familiarize yourself with the operation
Figure 2-9: Setting the Backgauge Adjustment
a
die set, turn the
.
Margin
Backgauge
Adjustment Knob
General Procedures
to
Advertisement
Table of Contents
