Starting a Job
Bypassing to a Downstream device
To prepare for starting a printing job and sending it to the Bypass
Destination, as well as the Downstream device, perform the following
procedures.
1
Set up the FusionPunch II in the Bypass Destination, as well as the
correct Punch mode (For FusionPunch II setup, refer to the Getting
Started section,
for the application, go to the Downstream device and enable it for
On-line operation.
2
From the
window and click on the
The
shown below.
2-20
). Once the FusionPunch II is setup
screen, open the
Icon.
Window will display, defaulted to the
Figure 2-18: The Finishing Window
tab, as
General Procedures