Wolf E Series Information Booklet page 46

Mode 7 - Last Error Code Recorded to Eeprom
To enter Mode 7 while engaged in diagnostic mode, touch the "+"
keypad on the left front control. When this is done the result will be:
• The bar lights on the left front control will illuminate 6 LEDs and
flash at the rate mentioned in Mode1.
• The bar lights on the left rear control will illuminate 0-6 LEDs
based on the last error code recorded to the Eeprom, and flash at
the rate mentioned in Mode1. If error codes were recorded, bar
lights 1-6 will correspond to one of six possible error codes.
NOTE: If no error codes were recorded, zero bar lights will illuminate.
Mode 8-14 -
To enter the corresponding Mode (8-14), touch the "+" keypad on the
left front control. When this is done the result will be:
• The bar lights on the left front control will illuminate the number of
LEDs according to the corresponding mode (8-14).
• The bar lights on the left rear control will illuminate 0-6 LEDs
based on the next to last error code recorded to the Eeprom and
flash at the rate mentioned in Mode1. Each additional Mode will
indicate the preceding error code recorded to the Eeprom. If error
codes were recorded, bar lights 1-6 will correspond to one of six
possible error codes.
NOTE: If no error codes were recorded, zero bar lights will illuminate.
NOTE: There can be a total of eight error codes recorded.
Preceding Error Codes Recorded to Eeprom
PAGE 46