Rear Panel; System Controls; Audio Source Inputs; Amplifier Outputs - Bose FREESPACE 4400 Owner's Manual

3.2 Rear panel

1
3
5

3.2.1 System controls

1 SENSE MICROPHONES – Input connectors for sensing
microphones used with the Auto Volume feature.
2
RS-232 – Standard RS-232 communications port. Provides
a communications interface for a PC running FreeSpace
Installer™ software. The FreeSpace 4400 Installer™ software is
used to configure the FreeSpace 4400 system.
Note: The RS-232 port should only be used to connect a
FreeSpace 4400 system to a PC.
3
WALL PLATE CONNECTIONS – Input connectors for AVM
1-Zone, AVM 2-Zone User Interface, or Page user interfaces.
4
REMOTE ON/OFF – An input connector for a remote
STANDBY switch.

3.2.2 Audio source inputs

5
LINE 1/LINE 2 – Unbalanced audio inputs
AUX MIC/LINE 3 – Balanced audio input with phantom power
PAGE/MIC/LINE 4 – Balanced audio input with phantom power
DIRECT IN/CONTROL – Balanced (DSP bypassed, full amplifier
gain) audio input which can override the sources playing on all
four output channels
3.0 Freespace
2
8
4 7
4400 Hardware Description
®
13

3.2.3 Amplifier outputs

6
ZONE OUTPUTS 1/2/3/4 – Loudspeaker connections for
four zones
Installer's Note: Please notice the polarity markings when
wiring loudspeaker cables to the ZONE OUTPUT connectors.
® 4400
CAUTION: DO NOT ground the minus (–) terminals.
7
ZONE 4 LINE OUT – A line-level output that duplicates the
program material from LINE 4. May be used to feed another
amplifier installed for a large zone. The 12V control output is used
to connect to Bose
8
MUSIC ON HOLD/PBX OUT – An audio output used to
provide music input to a PBX system

3.2.4 AC power

9
OUTPUT VOLTAGE – Sets the ZONE OUTPUT lines to 70/
100V.
10
POWER ON/OFF – Switches AC power on or off
11
Fuse –T6.3(6,3)A L 250V (100/120V) or
12
AC MAINS LINE CORD JACK – AC line voltage input
13
INPUT VOLTAGE – switches need to be configured for
proper input voltage.
13 of 66
6
9
® amplifier sequence inputs.
T3.15(3,15)A L 250V (220-240V).
10
11
12