Figure 3-11 Gtn 7Xx Gtn Setup Page; Gtn Setup Page - Garmin GTN 6 Series Maintenance Manual

3.3.3

GTN Setup Page

A brief overview of the pages that are accessed from the GTN Setup page are described below. To access
the GTN Setup page, touch the GTN Setup key from the Configuration Mode page.

Figure 3-11 GTN 7XX GTN Setup Page

ARINC 429
The ARINC 429 page allows the user to configure the ARINC 429 input and output ports on the GTN.
Both ARINC 429 formats and bus speeds are set from this configuration page.
RS-232
The RS-232 page allows the user to configure the RS-232 input and output ports on the GTN.
HSDB (Ethernet)
The HSDB (Ethernet) page allows the user to set which Ethernet ports are connected.
Interfaced Equipment
The Interfaced Equipment page allows the user to configure which LRUs are installed and interfaced to
the GTN. The transponder selection is automatically configured when a valid transponder configuration is
selected under the RS-232 page.
Main Indicator (Analog)
The Main Indicator (Analog) page allows the user to calibrate the OBS resolver, configure the CDI key,
selected course for GPS, and VLOC, as well as the V-Flag state.
Lighting
The Lighting page allows the user to set the display parameters that affect the backlight and key lighting
brightness.
190-01007-B1 GTN 6XX/7XX Part 27 AML STC Maintenance Manual
Rev. 4 Page 3-10