Ricoh Ri 100 Manual page 165

Web Image Monitor -
Configure WLAN
Settings (Simple) - 6
12. Turn off the printer
13. Check that the wireless access point/router is
operating.
14. Remove the LAN cable and Plug the wireless LAN
cable into the Ethernet port
15. Turn On the printer
A. It takes about 2 minutes to connect to the
wireless access point/router.
B. Wait for about 2 minutes after turning on the
printer.
16. Close the port cover
17. Print the configuration page to check whether
the printer has successfully connected to the
wireless access point/router.
18. Load the print media in the tray.
A. If the wireless LAN signal is reported as being
unavailable (0%) on the configuration page, the
printer is not connected to the wireless access
point/router.
15
17
4
DYX031
14
16
18