Table of Contents
Advertisement
2.
Remove the rear-facing webcam (2) and cable.
Reverse this procedure to install the rear-facing webcam.
System board
Description
System board equipped with a Balong V9R1 Cortex-A9 quad core 1.60-GHz processor, 1.0-GB
of system memory, 8-GB eMMC system storage, and a graphics subsystem with UMA memory
Before removing the system board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the display panel assembly (see
5.
Remove the connector board (see
6.
Disconnect the battery cable from the system board (see
7.
Remove the left and right speaker connector boards (see
Remove the system board:
1.
Lift the outside edge of the system board (1) until it rests at an angle.
Display panel assembly on page
Connector board on page
Battery on page
Spare part number
776019-001
15).
19).
20).
Speaker connector boards on page
System board
21).
25
Advertisement
Table of Contents
