Table of Contents
Advertisement
Battery
Description
2-cell, 6280-mAh, Li-ion, USB-charging battery (includes cable and double-sided adhesive)
Before removing the battery, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the connector board (see
WARNING!
a replacement battery provided by HP, or a compatible battery purchased from HP.
CAUTION:
information. To prevent loss of information, save your work or shut down the tablet through the
operating system before removing the battery.
Remove the battery:
1.
Remove the five Torx T5M1.3×3.7 screws (1) that secure the plastic frame to the back cover.
2.
Remove the three Phillips PM1.3×3.0 screws (2) that secure the plastic frame to the back cover.
3.
Remove the plastic frame (3).
The plastic frame is included in the back cover spare part kit, spare part number 776015-001.
20
Chapter 5 Removal and replacement procedures
Display panel assembly on page
To reduce potential safety issues, use only the battery provided with the tablet,
Removing a battery that is the sole power source for the tablet can cause loss of
Connector board on page
Spare part number
776016-001
15).
19).
Advertisement
Table of Contents
