Availability Of Suitable I/O Addresses - Siemens SINUMERIK 840D sl Configuration Manual

Procedure
To directly view after a configuration change (or after the compile) which I/O addresses differ
from the standard schema, proceed as follows:
1. Click "General" or "Compile" in the "Info" inspector window.
The message log is displayed.
Figure 6-4
The inspector window has the following options:
– All components and telegrams that differ from the default scheme are listed in the
– To switch directly to the detail view of the respective component or I/O address, click the
– To call the associated help entry in the information system of the TIA Portal, click the
2. Note the required information.
6.9.4

Availability of suitable I/O addresses

If the message is displayed that insufficient suitable I/O addresses are available, you must
release suitable I/O addresses.
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
The "Info > General" inspector window shows which default I/O addresses were already
assigned for each individual telegram.
"Message" column.
symbol in the "Go to" column.
symbol in the "?" column.
Configuring telegrams and drive units
6.9 Deviations from the standard I/O addressing schematic
145