4.
Align the pins on the replacement beam connector with the holes in the system board, and then carefully
install the beam connector (1) onto the socket on the system board.
5.
Without moving the beam connector, press the installation tool release tabs (2) together to release the
beam connector.
6.
Remove the installation tool (3).
7.
Align the holes on the beam connector bracket with the pins on the beam connector, and then install the
beam connector bracket (1).
8.
Install the three Phillips M2.0 × 2.9 broad head screws (2) to secure the beam connector and bracket to the
computer.
Graphics card
To remove the graphics card, use this procedure and illustration.
ENWW
Component replacement procedures
87