Storing The Machine; Replacing The Depth Wheel - Stihl FCS-KM Instruction Manual

NOTICE
Do not stand or kneel on the shaft!
WARNING
If the engine is started, the blade may
rotate as soon as the engine is running –
therefore blip the throttle trigger as soon
as the engine is running – the engine
begins to idle.
The other starting procedure is
described in the instruction manual for
the KombiEngine or basic power tool.
Switching off the engine
see instruction manual for the
N
KombiEngine or basic power tool
FCS-KM

Storing the Machine

For periods of 3 months or longer
Remove, clean and inspect the
N
cutting blade.
If the KombiTool is removed from
N
the KombiEngine and stored
separately: Fit the protective cap on
the drive tube to avoid dirt getting
into the coupling.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.

Replacing the Depth Wheel

Have the worn wheel replaced by a
specialist dealer. STIHL recommends
that maintenance and repair work be
carried out only by authorized STIHL
dealers.
Wheel
2
End of screw thread (1) is deformed
N
so that the wingnut (2) cannot be
lost
The wingnut can only be unscrewed
from the screw with lots of force. If the
parts are joined again after this, the
function of the "filler cap retainer" is no
longer assured. In this case, have the
screw and wingnut replaced with new
ones by a specialist dealer.
English
1
11